Your body, effectively called the operator cab, of a Bobcat Skid Steer must be in the raised position to get into the hydraulic gas filter and get a handle on linkages when restoration or preservation is required. Luckily, the engineers at Bobcat did a good job of designing the cab mounts, making this a fairly straightforward operation.

Eliminate any loose items, such as for example gloves, hard-hats or tools from the cab interior.

Locate the cab retaining bolts in the front corners of the cab. They're positioned in underneath of the cab on both sides of the doorway opening.

Use the 19-mm socket to show the nuts in a counter-clockwise direction to get rid of them. Remove the square washer located under each nut as well.

If you loved this posting and you would like to acquire more info about bobcat t300 problems kindly check out our page. Stand on top step of the loader and place one hand firmly on the bottom of both entry-assist hand rails. You should lift steadily on both rails to raise the cab. Make sure to lift the cab until it locks in place.

Lower the cab when done by raising the cab somewhat and driving in on the secure system on the fuel cab support piston. That releases the the secure and allows the cautious lowering of the cab.

Tips
- It can be possible to employ a wrench to eliminate the cab nuts but the process will undoubtedly be considerably slower.
- If you do not have a 19mm socket or wrench, a 3/4-inch size will fit and work equally well.
- Lowering the cab might be easier if you have a helper release the lock on the support piston.

Warnings
- Bobcat cabs are heavy. Lifting one requires considerable effort, even with the assistance supplied by the gas pistons. This is simply not a task for an individual with a back problem.
- Do not place any part of your body underneath the cab area before the cab is in the fully elevated position and supported by the lock on the gasoline support piston.